DIY PROJECT MATERIALS CALCULATOR

For Corrugated Panels

This calculator can be used to estimate the materials required for basic patio structures.

User Input (enter info in each field)

Width of Your Structure (Enter dimension in feet)

- +

Projection from Building (Enter dimension in feet)

- +

Pitch (a.k.a. Slope) (Enter dimension, in inches, that roof rises for each foot of roof projection from building)

- +

Panel length after accounting for roof pitch:

0.00 ft

Panel length rounded to the nearest foot:

0 ft

Calculated Purchase Requirements

Required Panel Length to be Purchased: 0ft

Required Quantity of Panels to be Purchased: 0

Required Boxes of Screws (Sold in 50 screws/bow): 0

Required Packs of Plastic Closure Strips: 0

Based on your Projection and Pitch, the Required Panel Length exceeds 12'. It is possible to overlap panels to extend the length of coverage, but this calculator cannot estimate using this installation method.



About this Calculator


Definitions

WIDTH: Distance from edge to edge of area to be covered with Palram's corrugated polycarbonate panels. Measurement entered in calculator should be in "feet." (i.e., 10 or 10.5)

PROJECTION: Distance from the building being attached to and the outermost point of the roof.

PITCH: This measurement indicates the slope of the roof. It is the distance between the high point of the roof and the low point of the roof, measured vertically against the wall of the structure.

NOTE: The calculator will estimate materials required for up to a 12' panel. Most DIY retailers do not stock panels longer than 12'.







Learn more about our corrugated accessories




Corrugated System Accessories

Note: Check your local building code requirements. Since Palram has no control of the use to which others may put this material, it does not guarantee the results.